• July 10, 2018 at 9:45 am #12713
    CandT
    Participant

    That’s where I’m at. My info is:
    Pixhawk: 2.1
    Arduplane: 3.8.5
    FlightDeck: 3.0.5
    Serial0-5_Protocol: 1,1,1,5,10,-1 (ie SERIAL4_PROTOCOL is 10)
    Sensors 5000-5007 all showing values that change occasionally
    Screen1 set to script “fltdk”
    Screen2 set to Nums, position 1 set to GPS and shows location correctly
    SD card has files from: “FlightDeck.zip” (1/24/17, 11,982,965 bytes) correctly installed (I think)

    I still get the “Turn on… ” message following long press of “Page”. Oddly, the initial display of the message merges rather than replaces the Main openTX screen(?). Any help would be greatly appreciated…

    July 10, 2018 at 10:17 am #12714
    Florent Martel
    Keymaster

    Thank you for this detailed information.

    If you’re able to “discover” the sensors in the 500x range, then you are likely on an older version of OpenTX.

    Which version of OpenTX are you running? Please update to 2.1 or later and try again.

    July 10, 2018 at 11:36 am #12716
    Florent Martel
    Keymaster

    > F…openTX version shows 2.1.9, Sep 14 2016. “Check for updates” shows
    “No updates available”. Do I need to update to 2.2.1?…J

    Just tested FD 3.0.5 with OpenTX 2.2.1 and it runs fine, so yes, please try that.

    July 10, 2018 at 3:21 pm #12717
    Florent Martel
    Keymaster

    > F…Updated to 2.2.1 and all is working now. Thanks for your help…J

    Glad to hear! Thanks.

You must be logged in to reply to this topic.