• November 20, 2018 at 1:30 pm #13665
    Alessio Giusti
    Participant

    I work with Pixhawk and Ardupilotsince 2014 with success , but I found a problem with a new machine.I start with Pixhawk 2.4.8 clone , FW 3.6.1 Copter , Serial 4 , protocol 10 , baud rate 57, I can’t found the signal from pin 2 (TX) of the Serial 4/5 connector , but if I change protocol to Mav (1) I found output serial data.
    When try to find sensors on my Taranis (Open TX 2.2.2) I can’t see no sensors .
    What can it be that escapes me?
    Thanks

    November 20, 2018 at 1:59 pm #13666
    Florent Martel
    Keymaster

    Hi Alessio,

    Thanks for letting us know. If you have more than one Pixhawk, you could troubleshoot to isolate the problem. This way, you would know if it comes from the flight controller hardware, the firmware or configuration, the telemetry cable, etc.

    Thanks,
    Florent

You must be logged in to reply to this topic.